ROSEROSA Matte Solid Faux Wood Architectural Film SG71 - Peel and Stick Timber Texture Vinyl Wrap for Furniture Refacing & Office Interiors

• Tools Required
  Sandpaper , Primer , Brush , Cutter knife , Ruler , Squeegee (Felt-tipped recommended) , Heat gun (or Hair dryer) , Cleaning cloth.
  

• Step 1 : Surface Preparation
  Clean the surface thoroughly to remove dust , oil , and moisture.
  If the surface is rough or uneven , smooth it out using sandpaper.
  For any holes or deep scratches , fill them with putty before sanding.
  

• Step 2 : Primer Application
  Apply a water-based primer to the surface,
  paying extra attention to corners and edges where lifting may occur.
  Allow the primer to dry completely before proceeding.
  This step is crucial for long-lasting adhesion.
  

• Step 3 : Measuring & Cutting
  Measure the surface area accurately.
  Cut the film with an extra margin of about 5~10cm (2~4 inches) on each side
  to allow for adjustments and wrapping around edges.
  

• Step 4 : Initial Application
  Peel off about 10cm of the release paper (liner) from the top.
  Align the film carefully with the top edge of the surface and attach it lightly.
  

• Step 5 : Squeegee & Air Removal
  Slowly peel off the remaining release paper while pressing the film down with a squeegee.
  Move from the center outward to push out air bubbles
  Apply firm pressure to ensure strong adhesion.
  

• Step 6 : Finishing & Trimming
  Use a cutter to trim the excess film along the edges.
  For corners and curved areas , apply heat using a heat gun.
  and press firmly to mold the film permanently into shape.

• To ensure color consistency, please overlap the products and maintain a consistent application direction. Reversing the direction of the film may lead to visible shading differences under certain lighting conditions.

ROSEROSA | A Brand You Can Trust Worldwide

ROSEROSA is a legally registered trademark in the United States (USPTO - Reg. No. 5,353,714) and Australia (IP Australia - Reg. No. 1,846,569). Our commitment to quality and innovation is protected by international standards, ensuring that you receive only authentic, premium-grade architectural films. Shop with confidence from a globally recognized brand.

Important Notes & Care Instructions

• Surface Compatibility
  Apply only to smooth, clean, and dry surfaces. Not recommended for textured walls, untreated plywood, or high-heat areas (e.g., near stove burners).
  

• Color Consistency
  Please purchase the required amount in a single order. Slight color variations may occur between different production batches.
  

• Installation Tip
  Use a squeegee or soft cloth to remove air bubbles during application. For curved edges, a standard hair dryer can be used to increase film flexibility.
  

• Removability
  While this film is designed for clean removal with minimal residue, the adhesive bond strengthens over time. Depending on the surface condition and duration of use, some surface damage may occur during removal.
  

At ROSEROSA, we are committed to providing premium products that meet rigorous international quality and safety standards. The following California Proposition 65 warning is a legal notice provided specifically for our customers in the State of California to ensure full regulatory transparency.

⚠️ WARNING : Cancer and Reproductive Harm - www.P65Warnings.ca.gov